logo

DigiPara Liftdesigner

LD 2020 Prerelease version, 23th of April 2019

TR-05693 (Finished)
Created by: MM
Last change: 12/12/2019 9:41:35 AM

IFC/BIM/3DDWG: Unify result

Naturally, this leads to changes to established exports. All of them can be previewed by setting the to-be-exported frames MASQUERADE_MODE to shfrmmTypeBIMExport = 3 and overridden by setting its CLASS_FILTERS.

Overridable changes to DWG export:
- the default exclude list disables shaft and floor level geometry
- transparent objects now actually are transparent
Non-Overridable changes to DWG export:
- shaft geometry, if enabled, is exported transparently but without CSG (cutting holes), the results were horrible on import anyway.

Overridable changes to BIM exports (actually from unrelated changes, but this is as good a place as any to list them):
- The default, LOD-Sheet-less, BIM export loses the scaffolding boards, entry floor level finishes and gains a wireframe block for the machine room

Manuel Moos 3/14/2019
Default_BIM
BIM_FROM_LOD_SHEET
3DDWG