logo

DigiPara Liftdesigner

LD 2021 Version, unreleased intermediate

TR-06512 (Finished)
Created by: MM
Last change: 4/7/2020 4:24:04 PM

Confusing default for EntryModes.emIndividualDimensions

Before this flag was introduced, it was effectively always on, so this is what the entry level default constructor now does.

The shaft wizard, on completion, disables it.

Add a new entry on an already populated side, and the flag gets copied from a previous entry, so it defaults to off then.

BUT, if you add a new entry on an entirely unused side, it will default to on.

Change suggestion: on adding the first entry on a side, find any other entry as sync soure.