DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change properties

API method: ILDXCarBalustrade5.PROFILEWIDTH

Treename: Shaft0.Car.Balustrade.

 ' from Samples/Src/LDXAPIExamples/Example_LDXCarBalustrade.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Car.Balustrade.", "LDXCarBalustrade~PROFILEWIDTH", "Change properties")>
    Public Shared Sub ChangeProperties(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.GetLDXObject("Shaft0.Car.Balustrade.") Is Nothing Then
            MsgBox("Car balustrade not found! Please reload the relevant .ld3 file.")
            Exit Sub
        End If

        Dim ldxCarBalustrade As DigiPara.LDX.LDXCarBalustrade = ldxDocument.Shafts(0).Car.CarBalustrade

        With ldxCarBalustrade
            ' Profile width
            .PROFILEWIDTH = 66
            ' Enable on all 4 sides
            .BalustradeMode = .BalustradeMode Or DigiPara.LDX.CarBalustradeModes.cbmLeft Or DigiPara.LDX.CarBalustradeModes.cbmRight Or
                DigiPara.LDX.CarBalustradeModes.cbmFront Or DigiPara.LDX.CarBalustradeModes.cbmRear
            ' Change height (calculated from the car top)
            .SetDZ(DigiPara.LDX.WallType.wtFront, .GetDZ(DigiPara.LDX.WallType.wtFront) + 111)
            .SetDZ(DigiPara.LDX.WallType.wtLeft, .GetDZ(DigiPara.LDX.WallType.wtLeft) + 111)
            .SetDZ(DigiPara.LDX.WallType.wtRear, .GetDZ(DigiPara.LDX.WallType.wtRear) + 111)
            .SetDZ(DigiPara.LDX.WallType.wtRight, .GetDZ(DigiPara.LDX.WallType.wtRight) + 111)
            ' Inward displacement from right car wall
            .SetDIST(DigiPara.LDX.WallType.wtRight, 0)
        End With

    End Sub