DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change bumper rail height

API method: ILDXCarBumperRail5.Mode

Treename: Shaft0.Car.Design.Wall2.Bumpers.Rail1.

 ' from Samples/Src/LDXAPIExamples/Example_LDXCarBumperRails.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Car.Design.Wall2.Bumpers.Rail1.", "LDXCarBumperRail~Mode", "Change bumper rail height")>
    Public Shared Sub ChangeBumperRailHeight(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.Bumpers.Rail1.") Is Nothing Then
            MsgBox("Desired car bumper rail not found! Please Reload the relevant .ld3 file.")
            Exit Sub
        End If

        If MsgBox("Change only the height of first bumper rail within the rear wall?" + Environment.NewLine + "If not all bumper rail heights will be changed within the wall rear.", MsgBoxStyle.YesNo) = MsgBoxResult.Yes Then
            With DirectCast(ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.Bumpers.Rail1.").LDXType, DigiPara.LDX.LDXCarBumperRail)
                ' Calculate the height of the first rear wall bumper rail independent of group
                .Mode = .Mode Or DigiPara.LDX.CarBumperRailModes.cbrIndividualZdimensions
                ' Height of the first rear bumper rail
                .Object.SetValue("DZ", 500)
            End With
        Else
            ' Height of all rear wall bumper rails
            TryCast(ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.Bumpers.").LDXType, DigiPara.LDX.LDXCarBumperRails).Object.SetValue("DZ", 500)
        End If
    End Sub