DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change kick plate height

API method: ILDXCarKickPlate5.Mode

Treename: Shaft0.Car.Design.Wall2.KickPlates.Plate0.

 ' from Samples/Src/LDXAPIExamples/Example_LDXCarKickPlates.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Car.Design.Wall2.KickPlates.Plate0.", "LDXCarKickPlate~Mode", "Change kick plate height")>
    Public Shared Sub ChangeKickPlateHeight(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.KickPlates.Plate0.") Is Nothing Then
            MsgBox("Desired car kick plate not found! Please Reload the relevant .ld3 file.")
            Exit Sub
        End If

        If MsgBox("Change only the height of first kick plate within the rear wall?" + Environment.NewLine + "If not all kick plate heights will be changed within the wall rear.", MsgBoxStyle.YesNo) = MsgBoxResult.Yes Then
            With DirectCast(ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.KickPlates.Plate0.").LDXType, DigiPara.LDX.LDXCarKickPlate)
                ' Calculate height of the first rear wall kick plate independent of group
                .Mode = .Mode Or DigiPara.LDX.CarKickPlateModes.ckplIndividualZdimensions
                ' Height of the first rear kick plate 
                .Object.SetValue("DZ", 200)
            End With
        Else
            ' Height of all rear wall kick plates
            TryCast(ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.KickPlates.").LDXType, DigiPara.LDX.LDXCarKickPlates).Object.SetValue("DZ", 200)
        End If
    End Sub