DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change the space on the left and right of a car wall

API method: ILDXCarWall5.GapLeft

Treename: Shaft0.Car.Design.Wall2.Panel0.

 ' from Samples/Src/LDXAPIExamples/Example_LDXCarWall.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Car.Design.Wall2.Panel0.", "LDXCarWall~GapLeft", "Change the space on the left and right of a car wall")>
 Public Shared Sub AirGap(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.") Is Nothing Then
         MsgBox("Desired car wall not found! Please Reload the relevant .ld3 file.")
         Exit Sub
     End If

     Dim ldxCarWall As DigiPara.LDX.LDXCarWall = DirectCast(ldxDocument.GetLDXObject("Shaft0.Car.Design.Wall2.").LDXType, DigiPara.LDX.LDXCarWall)

     If ldxCarWall.GapLeft < 100 Then
         ' the air gap leaves panel-less spaces on the left and right
         ldxCarWall.GapLeft = 200
         ldxCarWall.GapRight = 200
     Else
         ldxCarWall.GapLeft = 0
         ldxCarWall.GapRight = 0
     End If

 End Sub