DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Remove elevator

API method: ILDXDocument5.CreateNewShaft

 ' from Samples/Src/LDXAPIExamples/Example_GroupsConfiguration.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "", "LDXDocument~CreateNewShaft", "Remove elevator")>
    Public Shared Sub RemoveElevator(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.Shafts Is Nothing Or ldxDocument.Shafts(0) Is Nothing Then
            MsgBox("No valid shafts found to delete. Please load the .ld3 file and try again.")
            Exit Sub
        End If
        ' Delete the 1st shaft
        ldxDocument.CreateNewShaft(0, 0, 0, 0, 0, 0, 0, 0, 0, 0, -1, ldxDocument.Shafts(0).Comp.SX, 0)
        ' Update bank 2 start index
        ldxDocument.Shafts.BANK_2_START_SX -= 1
    End Sub