DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Add a hole

API method: ILDXEntries5.EntriesMode

Treename: Shaft0.Entries1.

 ' from Samples/Src/LDXAPIExamples/Example_LDXShaft.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Entries1.", "LDXEntries~EntriesMode", "Add a hole")>
 Public Shared Sub AddAHole(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.Entries1.Hole0.") Is Nothing Then
         MsgBox("Desired shaft hole not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     With ldxDocument.Shafts(0).GetEntries(DigiPara.LDX.WallType.wtFront)
         ' Add one hole
         .EntriesMode = DigiPara.LDX.EntriesModes.elmOneHole
         ' Ceiling hole dimensions
         .HOLE_DX = 333
         .HOLE_DY = 444
         ' Ceiling hole location
         .HOLE_X0 = -333
         .HOLE_Y0 = 111
     End With

 End Sub