DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change entry pocket properties

API method: ILDXEntry5.GetPocket

Treename: Shaft0.Entries1.E0.Pocket1.

 ' from Samples/Src/LDXAPIExamples/Example_LDXEntry.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Entries1.E0.Pocket1.", "LDXEntry~GetPocket", "Change entry pocket properties")>
 Public Shared Sub ChangeEntryPocketProperties(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.GetLDXObject("Shaft0.Entries1.E0.Pocket1.") Is Nothing Then
            MsgBox("Desired entry pocket not found! Please reload the relevant .ld3 file.")
            Exit Sub
        End If

        Dim ldxEntry As DigiPara.LDX.LDXEntry = DirectCast(ldxDocument.GetLDXObject("Shaft0.Entries1.E0.").LDXType, DigiPara.LDX.LDXEntry)
        With ldxEntry.GetPocket(1)
            ' Manually calculate the width
            .POCKET_MODE = .POCKET_MODE Or DigiPara.LDX.EntryPocketModes.epmWidthManual
            ' Depth
            .N_T = 222
            ' Width
            .N_B = 222
            ' Height of top pocket edge from the finished floor upwards
            .N_HO = 1444
            ' Height of bottom pocket edge from the finished floor downwards
            .N_HU = -1111
            ' Distance from the left entry corner
            .N_XL = 111
        End With

    End Sub