DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change traction machine Z position

API method: ILDXGear5.RELATIVE_DZ

Treename: Shaft0.Gear.

 ' from Samples/Src/LDXAPIExamples/Example_LDXGear.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Gear.", "LDXGear~RELATIVE_DZ", "[0361] Change traction machine Z position")>
 Public Shared Sub ChangeTractionMachineZPosition(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.Gear.") Is Nothing Then
         MsgBox("Gear not found!")
         Exit Sub
     End If

     ' Reference plane
     Dim ldxGear As DigiPara.LDX.LDXGear = ldxDocument.Shafts(0).Gear
     With ldxGear
         .GEAR_MODE = .GEAR_MODE Or DigiPara.LDX.GearModes.gmAlignCenter ' unrelated to z positioning

         ' cycle through modes
         Select Case .GEAR_MODE And DigiPara.LDX.GearModes.gmZPosRelativeMask
             Case 0
                 .GEAR_MODE = (.GEAR_MODE And Not DigiPara.LDX.GearModes.gmZPosRelativeMask) Or DigiPara.LDX.GearModes.gmZPosRelativeToOverhead
             Case DigiPara.LDX.GearModes.gmZPosRelativeToOverhead
                 .GEAR_MODE = (.GEAR_MODE And Not DigiPara.LDX.GearModes.gmZPosRelativeMask) Or DigiPara.LDX.GearModes.gmZPosRelativeToPit
             Case DigiPara.LDX.GearModes.gmZPosRelativeToPit
                 .GEAR_MODE = (.GEAR_MODE And Not DigiPara.LDX.GearModes.gmZPosRelativeMask) Or DigiPara.LDX.GearModes.gmZPosRelativeToTopFloor
             Case DigiPara.LDX.GearModes.gmZPosRelativeToTopFloor
                 .GEAR_MODE = (.GEAR_MODE And Not DigiPara.LDX.GearModes.gmZPosRelativeMask) Or DigiPara.LDX.GearModes.gmZPosRelativeToTopFloorPlusOPH
             Case DigiPara.LDX.GearModes.gmZPosRelativeToTopFloorPlusOPH
                 .GEAR_MODE = (.GEAR_MODE And Not DigiPara.LDX.GearModes.gmZPosRelativeMask) ' no additional bit means relative to machine room
             Case Else
                 .GEAR_MODE = (.GEAR_MODE And Not DigiPara.LDX.GearModes.gmZPosRelativeMask)
         End Select
     End With

     ' Reference plane location
     ldxGear.RELATIVE_DZ = 500
 End Sub