DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Take over hole without hmPosiByDim, enable hmPosiByDim

API method: ILDXHole5.PrimaryAxisMode

Treename: Shaft0.Entries1.E0.Panel0.Hole0.

 ' from Samples/Src/LDXAPIExamples/Example_LDXHole.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Entries1.E0.Panel0.Hole0.", "LDXHole~PrimaryAxisMode", "Take over hole without hmPosiByDim, enable hmPosiByDim")>
 Public Shared Sub PositionByParent(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     Dim o As DigiPara.LDX.LDXObject = ldxDocument.GetLDXObject("Shaft0.Entries1.E0.Panel0.Hole0.")
     If o Is Nothing Then
         MsgBox("Desired hole not found. Please reload the relevant .ld3 file.")
         Exit Sub
     End If
     Dim hole As DigiPara.LDX.LDXHole = DirectCast(o.GetLDXType(ObjectId.idHole), LDXHole)

     MakeVisible(ldxDocument, hole.Object.ParentObject.Comp)
     MakeVisible(ldxDocument, hole.Comp)

     With hole
         ' we can always enable positioning by dimensions
         .HoleMode = (.HoleMode Xor HoleModes.hmDisableInternalRules) Or HoleModes.hmPosiByDim
         If (.HoleMode And HoleModes.hmDisableInternalRules) = HoleModes.hmNone Then
             Return ' we just reset everything to defaults
         End If

         ' thoese holes should generally be positioned relative by their parent object, but projected into the wall
         ' these axis modes do the trick:
         .PrimaryAxisMode = MixedAxisModes.mamY Or MixedAxisModes.mamSourceWall
         .SecondaryAxisMode = MixedAxisModes.mamX Or MixedAxisModes.mamSourceParent
         .TertiaryAxisMode = MixedAxisModes.mamZ Or MixedAxisModes.mamSourceParent

         ' set position
         .Z0 = 200
         .X0 = 0

         ' increase size
         .DZ = .DZ * 2
     End With
 End Sub