DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Place lamps at separator beams

API method: ILDXLamps5.LPL_MODE

Treename: Shaft0.LampList.Lamp1.

 ' from Samples/Src/LDXAPIExamples/Example_LDXLamps.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.LampList.Lamp1.", "LDXLamps~LPL_MODE", "Place lamps at separator beams")>
 Public Shared Sub LampsAtSeparatorBeams(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.LampList.") Is Nothing Then
         MsgBox("Lamps not found!")
         Exit Sub
     End If

     With DirectCast(ldxDocument.GetLDXObject("Shaft0.LampList.").LDXType, DigiPara.LDX.LDXLamps)
         ' place on wall with separator beams
         With ldxDocument.Shafts(0).Console(4).RailBrackets
             .RBL_MODE = .RBL_MODE Or DigiPara.LDX.RailBracketsModes.rbmSeparatorBeam
         End With
         .Comp.Wall = 4

         ' place lamps at separator beam positions (lsmFixAtSeparatorBeam is for Y position)
         .LPL_MODE = .LPL_MODE Or DigiPara.LDX.LampsModes.lsmFixAtSeparatorBeam Or DigiPara.LDX.LampsModes.lsmZAtSeparatorBeams

         ' this makes sure to put one lamp on each beam
         .DZ_START = 0
         .DZ_END_MIN = 0
         .DZ_DELTA = 0

         ' add a little Z offset to have the lamp not tangle awkwardly at the top of the beam
         .DZ_OFFSET = -100

         ' avoid collision with ladder
         .Item(0).DELTA = 500

         ' make visible
         Helpers.EnsureVerticalView(ldxDocument, .Comp)
     End With

 End Sub