DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change properties

API method: ILDXLandingDoor5.XN

Treename: Shaft0.Entries1.E0.ShaftDoor.

 ' from Samples/Src/LDXAPIExamples/Example_LDXLandingDoor.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Entries1.E0.ShaftDoor.", "LDXLandingDoor~XN", "Change properties")>
 Public Shared Sub ChangeProperties(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.Entries1.E0.ShaftDoor.") Is Nothing Then
         MsgBox("Desired landing door not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     With DirectCast(ldxDocument.GetLDXObject("Shaft0.Entries1.E0.ShaftDoor.").LDXType, DigiPara.LDX.LDXLandingDoor)
         ' Make this door different from the other landing doors
         .SD_MODE = .SD_MODE Or DigiPara.LDX.LandingDoorModes.ldmUserdefined
         ' Extra sideways displacement of shaft door
         .XN = 88
         ' Extra upwards displacement of shaft door
         .ZN = 111
     End With

     DirectCast(ldxDocument.GetLDXObject("Shaft0.Entries1.E0.ShaftDoor.").LDXType, DigiPara.LDX.LDXLandingDoor).Door.DoorDimTab.GetValue("DD_DW")
 End Sub