|
DigiPara Liftdesigner LDX API
|
API method: ILDXRopeCompensationUnit5.DZ
Treename: Shaft0.RopeCompensationUnit.
' from Samples/Src/LDXAPIExamples/Example_LDXRopeCompensationUnit.vb
<APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.RopeCompensationUnit.", "LDXRopeCompensationUnit~DZ", "Change properties")>
Public Shared Sub ChangeProperties(ByRef ldxDocument As DigiPara.LDX.LDXDocument)
If ldxDocument.GetLDXObject("Shaft0.RopeCompensationUnit.") Is Nothing Then
MsgBox("Desired rope compensation unit not found! Please reload the relevant .ld3 file.")
Exit Sub
End If
With ldxDocument.Shafts(0).RopeCompensation(0)
' Change distance to pit
.DZ = 555
' Change displacement of pulley from the rear wall
.PULLEY_Y0 = -555
End With
End Sub