DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Add more rooms

API method: ILDXShaft5.EXTRA_MACHINEROOM_COUNT

Treename: Shaft0.ExtraMachineryRoom0.

 ' from Samples/Src/LDXAPIExamples/Example_LDXShaft.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.ExtraMachineryRoom0.", "LDXShaft~EXTRA_MACHINEROOM_COUNT", "Add more rooms")>
 Public Shared Sub AdditionalMachineRooms(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.") Is Nothing Then
         MsgBox("Shaft not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     ' make rooms visible
     For Each frame As DigiPara.LDX.LDXSheetFrame In ldxDocument.Sheets.ActiveSheet
         frame.VisibleProductGroups = frame.VisibleProductGroups Or DigiPara.LDX.SheetFrameProductGroups.shfpMachineryRoom Or DigiPara.LDX.SheetFrameProductGroups.shfpElectricalEquipments
     Next

     With ldxDocument.Shaft
         If .EXTRA_MACHINEROOM_COUNT < 2 Then
             ' increase count
             .EXTRA_MACHINEROOM_COUNT = 2

             With .ExtraMachineRoom(0)
                 ' activate; most contained components are off, then
                 .Object.Active = True

                 ' position
                 .POS_DY0 = .Object.Shaft.Room.DEPTH + 600
                 .Room.Y0 = .POS_DY0
                 .Room.DEPTH = 1500
             End With

             With .ExtraMachineRoom(1)
                 ' activate and load from database; this comes with typical machine room components.
                 .Comp.ChangePartRID64(1, 0)
                 ' note: these components are invisible in the regular plan view.

                 ' position
                 .POS_DY0 = .Object.Shaft.Room.DEPTH + 600
                 .Room.Y0 = .POS_DY0
                 .POS_DX0 = .Object.Shaft.Room.Width + 600
                 .Room.X0 = .POS_DX0
                 .POS_DZ = .Object.Shaft.Room.Height
                 .Room.Z0 = .POS_DZ
                 .Room.DEPTH = 1400
             End With
         Else
             ' deactivate again
             .EXTRA_MACHINEROOM_COUNT = 0
         End If
     End With
 End Sub