DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change machine room wall material of first shaft

API method: ILDXShaft5.MachineRoom

 ' from Samples/Src/LDXAPIExamples/Example_GroupsConfiguration.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "", "LDXShaft~MachineRoom", "Change machine room wall material of first shaft")>
    Public Shared Sub ChangeMachineRoomWallMaterialOfFirstShaft(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.GetLDXObject("Shaft0.MachineryRoom.") Is Nothing Then
            MsgBox("Machine room not found")
            Exit Sub
        End If

        With ldxDocument.Shafts(0).MachineRoom.Room
            If MsgBox("Change all machine room wall material of the first shaft? If not only the front machine room wall material of the first shaft will be changed.", MsgBoxStyle.YesNo) = MsgBoxResult.Yes Then
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmFrontLeft, DigiPara.LDX.ShaftMaterial.smClassic)
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmLeft, DigiPara.LDX.ShaftMaterial.smClassic)
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmRearLeft, DigiPara.LDX.ShaftMaterial.smClassic)
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmRear, DigiPara.LDX.ShaftMaterial.smClassic)
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmRearRight, DigiPara.LDX.ShaftMaterial.smClassic)
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmRight, DigiPara.LDX.ShaftMaterial.smClassic)
                .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmFrontRight, DigiPara.LDX.ShaftMaterial.smClassic)
            End If
            .SetWallMaterial(DigiPara.LDX.WallTypeForMaterial.wtfmFront, DigiPara.LDX.ShaftMaterial.smClassic)
        End With

    End Sub