DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change pit height

API method: ILDXShaft5.PIT

2 code examples follow.

Example 1: Change pit height

 ' from Samples/Src/LDXAPIExamples/Example_GroupsConfiguration.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "", "LDXShaft~PIT", "Change pit height")>
    Public Shared Sub ChangePitHeight(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

        If ldxDocument.Shafts Is Nothing Or ldxDocument.Shafts.Count = 0 Then
            MsgBox("Shafts not found. Please reload .ld3 file.")
            Return
        End If
        ' Change the pit height of first shaft
        For Each ldxShaft As DigiPara.LDX.LDXShaft In ldxDocument.Shafts
            If ldxShaft.Comp.IX <> ldxDocument.Shafts(0).Comp.IX Then
                ldxShaft.SHAFT_MODE = ldxShaft.SHAFT_MODE Or DigiPara.LDX.ShaftModes.smManualPit
            End If
        Next
        ldxDocument.Shafts(0).PIT = 2500
    End Sub

Example 2: [0247] Change shaft height

 ' from Samples/Src/LDXAPIExamples/Example_LDXShaft.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.", "LDXShaft~PIT", "[0247] Change shaft height")>
 Public Shared Sub ChangeShaftHeight(ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.") Is Nothing Then
         MsgBox("Shafts not found!")
         Exit Sub
     End If

     ' Shaft height
     ldxDocument.Shafts(0).PIT = 8000
     ldxDocument.Shafts(0).Head = 8000

     ldxDocument.Shafts(0).Object.GetDim("HEAD").Calculate()

 End Sub