DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change pit door properties

API method: ILDXShaft5.PitDoor

Treename: Shaft0.Door.

 ' from Samples/Src/LDXAPIExamples/Example_LDXShaft.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Door.", "LDXShaft~PitDoor", "Change pit door properties")>
 Public Shared Sub ChangePitDoorProperties(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.Door.") Is Nothing Then
         MsgBox("Pit door in shaft not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     Dim ldxMachineRoomDoor As DigiPara.LDX.LDXMachineRoomDoor = ldxDocument.Shafts(0).PitDoor
     ' Enable pit door and set manufacturer
     ldxMachineRoomDoor.Comp.ChangePartRID64(1, 0)
     ' Change surface color
     ldxMachineRoomDoor.Comp.VisualMaterial.PGOGL_RID64 = 11000
     ' Change height
     ldxMachineRoomDoor.Height = 2222
     ' Change width
     ldxMachineRoomDoor.Width = 1111
     ' Change elevation
     ldxMachineRoomDoor.DZ0 = 333

 End Sub