DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Enable a rope compensation unit and set manufacturer

API method: ILDXShaft5.RopeCompensation

Treename: Shaft0.RopeCompensationUnit.

 ' from Samples/Src/LDXAPIExamples/Example_LDXShaft.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.RopeCompensationUnit.", "LDXShaft~RopeCompensation", "Enable a rope compensation unit and set manufacturer")>
 Public Shared Sub EnableARopeCompensationUnitAndSetManufacturer(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.RopeCompensationUnit.") Is Nothing Then
         MsgBox("Desired rope compensation unit not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If
     ' Enable and change manufacturer
     ldxDocument.Shafts(0).RopeCompensation(0).Comp.ChangePartRID64(1, 0)

 End Sub