DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Add another traveling cable

API method: ILDXShaft5.TRAVELING_CABLE_COUNT

Treename: Shaft0.TravelingCable5.

 ' from Samples/Src/LDXAPIExamples/Example_LDXShaft.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.TravelingCable5.", "LDXShaft~TRAVELING_CABLE_COUNT", "Add another traveling cable")>
 Public Shared Sub AdditionalTravelingcable(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.") Is Nothing Then
         MsgBox("Shaft not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     ' make traveling cables visible
     For Each frame As DigiPara.LDX.LDXSheetFrame In ldxDocument.Sheets.ActiveSheet
         frame.VisibleProductGroups = frame.VisibleProductGroups Or DigiPara.LDX.SheetFrameProductGroups.shfpElectricalEquipments

     Next

     With ldxDocument.Shaft
         If .TRAVELING_CABLE_COUNT < 6 Then
             ' increase count
             .TRAVELING_CABLE_COUNT = 6
             ' activate
             .TravelingCable(5).Comp.ChangePartRID64(1, 0)
         Else
             ' deactivate again
             .TRAVELING_CABLE_COUNT = 5
         End If
     End With
 End Sub