DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Drive visible box with rules

API method: ILDXSheetFrame5.VisibleBoxRules

Treename: Sheets.LdvSheet1.LdvFrame2.

 ' from Samples/Src/LDXAPIExamples/Example_LDXSheetFrame.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Sheets.LdvSheet1.LdvFrame2.", "LDXSheetFrame~VisibleBoxRules", "Drive visible box with rules")>
 Public Shared Sub DisplayARectangularSectionWithRules(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetObject("Sheets.LdvSheet1.LdvFrame3.") Is Nothing Then
         MsgBox("Desired sheet frame not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     With DirectCast(ldxDocument.GetLDXObject("Sheets.LdvSheet1.LdvFrame3.").LDXType, DigiPara.LDX.LDXSheetFrame)
         ' switch to side view
         .Reset(DigiPara.LDX.SheetFrameViewType.shfvtVertical, DigiPara.LDX.SheetFrameViewDirections.shfvdToLeftWall, DigiPara.LDX.SheetFrameResetOptions.shfrrstInitText)
         .FrameMode2 = .FrameMode2 Or DigiPara.LDX.SheetFrameModes2.shfrm2CarBasepointIsFrameX0

         ' Display visibile box 
         .FrameMode2 = .FrameMode2 Or DigiPara.LDX.SheetFrameModes2.shfrm2UseVisibleBox

         Dim ruleBox As DigiPara.LDX.LDXWorldPositionRuleBox = .VisibleBoxRules

         ' cut bottom sligtly below car
         ' Shaft. is the first visible shaft of the view frame
         With ruleBox.Rule(DigiPara.LDX.WorldPositionRuleModes.wprmZMin)
             .ReferenceTreeName = "Shaft.Car."
             .DeltaRule = "-100 - LD(""Me.DIM108"")"
         End With

         ' cut top sligtly above car frame (the upper guide shoe, to be precise)
         With ruleBox.Rule(DigiPara.LDX.WorldPositionRuleModes.wprmZMax)
             .ReferenceTreeName = "Shaft.Car.Frame."
             .DeltaRule = "100 + LD(""Me.L_CarFrameDimTab.CFD_GS_Z_TOP"")"
         End With

         ' cut at the half of the rear wall
         ' "Me." in the rules always references the reference object, in this case the shaft.
         With ruleBox.Rule(DigiPara.LDX.WorldPositionRuleModes.wprmYMax)
             .ReferenceTreeName = "Shaft."
             .DeltaRule = "LD(""Me.DEPTH"") + LD(""Me.W_2"")*.5"
         End With

         ' box borders we do not care about are extended to practically infinity, so
         ' we do not have to worry about YMin or XMin/Max.

         ' after the example ran, observe how the visible box adapts to changes in shaft depth, wall width,
         ' car position and car frame dimensions.
     End With

 End Sub