DigiPara Liftdesigner LDX API
Loading...
Searching...
No Matches
Change Properties

API method: ILDXWallOpening5.T_AUSBR_B

Treename: Shaft0.Entries1.E0.Opening.

 ' from Samples/Src/LDXAPIExamples/Example_LDXWallOpening.vb

    <APIHelpAttribute(APIHelpModes.FireCalcModel Or APIHelpModes.LoadLD3File, {APIHelpModes.InputParaLDXDoc}, "Shaft0.Entries1.E0.Opening.", "LDXWallOpening~T_AUSBR_B", "Change Properties")>
 Public Shared Sub ChangeProperties(ByRef ldxDocument As DigiPara.LDX.LDXDocument)

     If ldxDocument.GetLDXObject("Shaft0.Entries1.E0.Opening.") Is Nothing Then
         MsgBox("Wall opening in front entries not found! Please reload the relevant .ld3 file.")
         Exit Sub
     End If

     With DirectCast(ldxDocument.GetLDXObject("Shaft0.Entries1.E0.Opening.").LDXType, DigiPara.LDX.LDXWallOpening)
         With DirectCast(ldxDocument.GetLDXObject("Shaft0.Entries1.E0.Jamb.").LDXType, DigiPara.LDX.LDXJamb)
             ' Calculate wall opening height and width manually
             .JAMB_MODE = .JAMB_MODE Or DigiPara.LDX.JambModes.jmWowManual Or DigiPara.LDX.JambModes.jmWohManual
             ' The horizontal addition to the opening's sides
             .JambTypeTab.SetValue("JT_WOW_CONSTANT", 0)
         End With

         If .T_AUSBR_H < 3000 Then
             ' The opening height
             .T_AUSBR_H = 3000
             ' The opening width
             .T_AUSBR_B = 1700
             ' The left horiontal dispalacement of the opening (the old way; one needs to call LDXDim.Calculate to make the change apply)
             .XRIGHT = 0
             .Object.GetDim("XRIGHT").Calculate()
         Else
             ' The opening height
             .T_AUSBR_H = 2800
             ' The opening width
             .T_AUSBR_B = 1400
             ' The left horiontal dispalacement of the opening (the center of the opening relative to the left shaft wall)
             .T_AUSBR_X0 = .T_AUSBR_B/2
         End If
     End With

 End Sub